Lenze 931W - Manual (Page 81)

Index 11

81 K-HB 13.0001-EN 2.1
P
Parameter change rights (PNU 927), 52
Parameter numbers, 51
PCV mechanism, 41
Personnel, qualified, 10
Pollution, 13
Profibus parameters (PNU 106), 67
R
Reading the set speed (example 2), 47
Reference parameter (PNU 101), 62
Request parameter change rights (example 1), 46
Response identification, 44
Reversal (example 4), 49
S
Safety instructions, 10
- definition, 12
- design, 12
- general, 11
Selector switch - control word bit 11 (PNU 933), 54
Selector switch - control word bit 12 ... 15
(PNU 934 ... 937), 54
Selector switch - control word bit 8 (PNU 931), 53
Selector switch - control word bit 9 (PNU 932), 54
Selector switch - status word bit 11 (PNU 939), 56
Selector switch - status word bit 12 (PNU 940), 56
Selector switch - status word bit 13 (PNU 941), 57
Selector switch - status word bit 14 (PNU 942), 57
Selector switch - status word bit 15 (PNU 943), 57
Selector switch - status word bit 8 (PNU 938), 55
Selector switch for operating mode (PNU 930), 52
Service parameter (PNU 105), 66
Site altitude, 13
Specification of the transmission cable, 16
State machine, 33
Station address (PNU 918), 51
Status (PNU 1000), 68
Structure of parameter identification (PKE), 42
Structure of the parameter characteristic value, 42
Synchronisation of several devices, 50
System parameters (PNU 104), 65
T
Technical data, 13
Transfer into non-volatile memory (PNU 971) , 59
Transfer of PPO with PROFIBUS-DP, 50
Transmission cable, specification, 16
Troubleshooting and fault elimination, 76
V
Preface, 6
W
Warranty, 9
Waste disposal, 9