Lenze 931W - Manual (Page 45)

Parameter channel (PCV mechanism)
Job and response processing
Error numbers at response
7

45 K-HB 13.0001-EN 2.1
7.3.3 Error numbers at response
Error number Information Detailed description
0 Impermissible PNU The parameter number is not assigned.
1 Parameter value cannot be
changed
This is a non-writable object, e.g. an actual value.
2 Lower or upper value limit
exceeded
The permissible writable limit range of the object has been
exceeded. Please observe object limits.
3 Faulty subindex The indicated subindex of the object does not exist or a
format error exists. Check entries.
4 No array The addressed object is no array type.
5 Wrong data type The object has been addressed as a wrong data type. See
job identification table.
6 No setting permitted (only
resettable)
No setting permitted (only resettable)
7 Describing element cannot be
changed
Elements such as the serial numbers cannot be changed.
8 PPO - Write requested in the IR is
not available
When installing the hardware a wrong data type was
selected. Please check the HW settings.
9 Description data not available
10 Wrong access group Access error! The PROFIBUS interface has no parameter
change rights. See PNU 927.
Possible error: Parameter change rights have not been
requested. The operating program and PROFIBUS master try
to access the drive simultaneously. Wrong software
settings in the operating program. (See activation of
PROFIBUS)
11 No parameter change rights Parameter change rights not requested or access not
possible.
12 Wrong password A password has been assigned which must be entered for
processing. See password.
13 Text in cyclic traffic cannot be
read
14 Name in cyclic traffic cannot be
read
15 No text array available
16 PPO - Write is missing When installing the hardware a wrong data type was
selected. Please check the HW settings.
17 Job cannot be executed due to
operating status
Check operating status. Is an error pending at the drive?
Errors can be observed via the software in the online level 1
under Status.
18 Other errors
19 ... 100 Date in the cyclic traffic cannot
be read
Tab. 21 Overview of error messages - job identifications
The error numbers 0 ... 100 are defined or reserved profile-oriented.