ETC Matrix MkII Dimming System - Manual (Page 38)

Table of Contents 33
parts of the dimmer devices, including the front panel illumination until such time that
the DMX signal is re-established (as soon as the control desk is switched on).
To set the dimmer device to ‘Sleep’ mode
1. Select INSTALL from the home menu.
2. Press DOWN or UP or use the rotary encoder to choose GENERAL SETTINGS
menu. Press SELECT.
3. Press DOWN or UP or use the rotary encoder to choose SLEEP MODE menu.
Press SELECT.
GENERAL SETTINGS
SLEEP MODE: [OFF]
CANCEL SAVE
4. Use the rotary encoder to choose either ON (active) or OFF (disabled).
5. Press SAVE to leave the menu and record the changes or CANCEL (to leave
the previous settings unchanged).
Check ventilation
Matrix has an integral test facility to check if the internal ventilation fans are operating
correctly using a manual control override.
To check the ventilation
1. Select INSTALL from the home menu.
2. Press DOWN or UP or use the rotary encoder to choose BLOWER TEST menu.
Press SELECT.
3. The display shows:
BLOWER TEST MENU
SINGLE BLOWER
UP DOWN SELECT HOME
4. Use the rotary encoder to choose either single or all fans (blowers). Single fans
can be accessed using UP and DOWN.
5. Press HOME to leave the menu.
Return to factory settings
The Matrix device is supplied with a set of factory default settings and software set-
up parameters which configure the internal memory and performance characteristics.
It is advisable to reset the dimmer software to the original factory settings in the case
of a significant software update, or when a dimmer device is replaced.
To reset the dimmer device to factory default settings
1. Select INSTALL from the home menu.
2. Press DOWN or UP or use the rotary encoder to choose RETURN TO
FACTORY SETTINGS menu. Press SELECT.