ETC Matrix MkII Dimming System - Manual (Page 23)

18
SELECT ETHERNET GATEWAY ADDRESS
AAA BBB CCC DDD
IP ADDRESS [010] 001 001 001
<<<<< >>>>>> EDIT CANCEL SAVE
5. Use the rotary encoder to choose the address number and press >>>> or <<<<
to tab other 3-digit groups.
6. Press ENTER to leave the menu, then either SAVE (to record the changes) or
CANCEL (to leave the previous settings unchanged).
To set-up the merger IP address:
1. Select INSTALL from the home menu
2. Press DOWN or UP or use the rotary encoder to choose MERGER ETHERNET
MENU. Press SELECT.
3. This accesses the Merger’s Ethernet menu tree. Press DOWN or UP or use the
rotary encoder to choose IP ADDRESS menu. Press SELECT.
4. The screen shows:
SELECT ETHERNET ADDRESS
AAA BBB CCC DDD
IP ADDRESS [010] 001 002 002
<<<<< >>>>>> EDIT CANCEL SAVE
5. Use the rotary encoder to choose the address number and press >>>> or <<<<
to tab other 3-digit groups.
6. Press ENTER to leave the menu, then either SAVE (to record the changes) or
CANCEL (to leave the previous settings unchanged).
To set-up the merger subnet mask:
1. Select INSTALL from the home menu
2. Press DOWN or UP or use the rotary encoder to choose MERGER ETHERNET
SETUP menu. Press SELECT.
3. This accesses the Merger’s Ethernet menu tree. Press DOWN or UP or use the
rotary encoder to choose SUBNET MASK menu. Press SELECT.
4. The screen shows:
SELECT ETHERNET SUBNET MASK
AAA BBB CCC DDD
SUBNET MASK [255] 255 255 000
<<<<< >>>>>> EDIT CANCEL SAVE