DATOptic ARC-1680 Series - Manual (Page 92)

BIOS CONFIGURATION
92
I/O Port Addr : 28000000h, F2(Tab): Select Controller, F10: Reboot System
ArrowKey Or AZ:Move Cursor, Enter: Select, ESC: Escape, L:Line Draw, X: Redraw
Areca Technology Corporation RAID Controller
Main Menu
Quick Volume/Raid Setup
Raid Set Function
Volume Set Function
Physical Drives
Raid System Function
Hdd Power Management
Ethernet Configuration
View System Events
Clear Event Buffer
Hardware Monitor
System information
Ethernet Configuration
Ethernet Configuration
DHCP Function : Enable
Local IP Address : 192.168.001.100
HTTP Port Number : 80
Telnet Port Number : 23
SMTP Port Number : 25
EtherNet Address : 00. 04. D9.7F .FF. FF
HTTP Port Number : 80
Edit The HTTP Port Number
0080 0
I/O Port Addr : 28000000h, F2(Tab): Select Controller, F10: Reboot System
ArrowKey Or AZ:Move Cursor, Enter: Select, ESC: Escape, L:Line Draw, X: Redraw
Areca Technology Corporation RAID Controller
Main Menu
Quick Volume/Raid Setup
Raid Set Function
Volume Set Function
Physical Drives
Raid System Function
Hdd Power Management
Ethernet Configuration
View System Events
Clear Event Buffer
Hardware Monitor
System information
Ethernet Configuration
Ethernet Configuration
DHCP Function : Enable
Local IP Address : 192.168.001.100
HTTP Port Number : 80
Telent Port Number : 23
SMTP Port Number : 25
EtherNet Address : 00. 04. D9.7F .FF. FF
Telnet Port Number : 23
Edit The Telent Port Number
0023 0
3.7.7.4 Telnet Port Number
To manually configure the “Telent Port Number” of the controller,
move the cursor bar to “Telent Port Number” item, then press
the Enter key to show the default address setting in the RAID
controller. You can then reassign the default “Telent Port Num-
ber” of the controller.
3.7.7.5 SMTP Port Number
To manually configure the “SMTP Port Number” of the control-
ler, move the cursor bar to the main menu “Ethernet Configu-
ration” function item and then press Enter key. The “Ethernet
Configuration” menu appears on the screen. Move the cursor
bar to “SMTP Port Number” item, then press Enter key to show
the default address setting in the RAID controller. You can then
reassign the default “SMTP Port Number” of the controller.