DATOptic ARC-1680 Series - Manual (Page 89)

BIOS CONFIGURATION
89
I/O Port Addr : 28000000h, F2(Tab): Select Controller, F10: Reboot System
ArrowKey Or AZ:Move Cursor, Enter: Select, ESC: Escape, L:Line Draw, X: Redraw
Areca Technology Corporation RAID Controller
Main Menu
Quick Volume/Raid Setup
Raid Set Function
Volume Set Function
Physical Drives
Raid System Function
Hdd Power Management
Ethernet Configuration
View System Events
Clear Event Buffer
Hardware Monitor
System information
Ethernet Configuration
Main Menu
Quick Volume/Raid Setup
Raid Set Function
Volume Set Function
Physical Drives
Raid System Function
Hdd Power Management
Ethernet Configuration
View System Events
Clear Event Buffer
Hardware Monitor
System information
Hdd Power Management
I/O Port Addr : 28000000h, F2(Tab): Select Controller, F10: Reboot System
ArrowKey Or AZ:Move Cursor, Enter: Select, ESC: Escape, L:Line Draw, X: Redraw
Areca Technology Corporation RAID Controller
Hdd Power Management
Stagger Power On
Time To Low Power Idle
Time To Low RPM Mode
Time To Spin Down Hdd Time To Spin Down Hdd
Spin Down Hdd
Disabled
1
3
5
10
15
20
30
40
60
Disabled
3.6.7.4 Time To Spin Down Idle Hdd (Minutes)
This function can automatically spin down the drive if it hasn't
been accessed for a certain amount of time. This value is used
by the drive to determine how long to wait (with no disk activity,
before turning off the spindle motor to save power.)
3.7.7 Ethernet Configuration
Use this feature to set the controller Ethernet port configuration.
It is not necessary to create reserved disk space on any hard disk
for the Ethernet port and HTTP service to function; these func-
tions are built into the controller firmware.move the cursor bar to
the main menu “Ethernet Configuration Function” item and then
press the Enter key. The “Ethernet Configuration” menu appears
on the screen. Move the cursor bar to an item, then press Enter
key to select the desired function.