DATOptic ARC-1680 Series User Manual

Page 110

ARCHTTP PROXY SERVER INSTALLATION

110

usr/local/sbin). Or

(1). Download from the www.areca.com.tw or from the email

attachment.

2. You must have administrative level permissions to install SATA

RAID controller ArcHttp proxy server software. This procedure

assumes that the SATA RAID hardware and driver are installed and

operational in your system.

The following details are the installation procedure of the SATA

RAID controller for Linux ArcHttp proxy server software.

(1).Run the Archttp proxy server by using the following command:

Usage: ./archttp32 (TCP_PORT) or ./archttp64 (TCP_PORT). It

depends on your OS version.

Parameters: TCP_PORT value= 1~65535 (If TCP_PORT assigned,

Archttp will start from this port. Otherwise, it will use the setting in

the archttpsrv.conf or default 81). This is the port address assigning

for the first adapter.

Such as: archttp64 1553

(2). Archttp server console started, Controller card detected then

ArcHttp proxy server screen appears.

Areca HTTP proxy server V1.80.240 for Areca RAID controllers.

Controller(s) list

--------------------------------------------

Controller[1](PCI) : Listen to port[1553].

Cfg Assistant : Listen to port[1554].

Binding IP:[0.0.0.0]

Note: IP[0.0.0.0] stands for any ip bound to this host.

--------------------------------------------

##############################

Press CTRL-C to exit program!!

##############################

Controller [1] Http: New client [9] accepted

Controller [1] Http: New Recv 243 bytes

Controller [1] Http: Send [174] bytes back to the client