Dascom LA48N/LA48W User Guide - Manual (Page 59)

Printing
4-3
Macro 1 and Macro 2 Settings
When you switch from one macro to another, each modification you made using the
control panel for the Top-of-Form option or the Protocol option is lost, and the values
of these options stored in the new macro become active.
The following tables list default values of options for print features. The former is
for options in Macro 1 and Macro 2 and the latter is for options independent of Macro
selection.
Print Feature
Factory Settings
Macro 1 Macro 2
Protocol
Protocol serial
Protocol parallel
Protocol USB Port dependent
DEC PPL2
EPSON-ESC
EPSON-ESC Port dependent
DEC PPL2
IBM PPX24
IBM PPX24
Font
Horizontal pitch
Vertical pitch Draft
10 cpi
6 lpi Draft
10 cpi
6 lpi
Form length
Left margin
Top of Form
1
Top margin
Bottom margin
11 inches
1 column
0/60 inch
1 line
66 lines 11 inches
1 column
0/60 inch
1 line
66 lines
Line mode
Paper source
2
Print direction
LF = LF, CR = CR
Tractor
Soft control LF = LF, CR = CR
Tractor
Soft control
DEC defaults
DEC printer ID
Auto wrap
EOT disconnect
Initial report
Auto answerback
Answerback on ENQ
DEC G0 character set
DEC user preference char-
acter set
PPL2
Wrap
No disconnect on EOT
No
No
No
US ASCII
DEC Supplemental PPL2
Wrap
No disconnect on EOT
No
No
No
US ASCII
DEC Supplemental
IBM&Epson
Default Character set
CP 437 CP 437
IBM defaults
IBM set 1 or 2
IBM double height
IBM AGM
IBM set 1
No
No IBM set 1
No
No