Dascom LA48N/LA48W User Guide - Manual (Page 45)

Paper Handling
3-13
5.
Position the right tractor (as seen from the rear of the printer). Push the right
locking lever down to secure the tractor. Center the middle forms support.
Positioning the tractors
Adjusting the left margin
Below the right tractor, as seen from the back, there is a tractor guide, short inch-
based ruler graduated in 10 columns per inch. Use the ruler to help position the trac-
tor. When the paper edge is positioned to the left most line, the left margin is approx-
imately 12 mm (0.5 inch) including perforation area.
Ajusting the left margin
6.
Fit the paper feed holes onto the left and right tractor pins. Adjust the left tractor
(as seen from the rear of the printer) to the width of the form. Close the paper
holders.
7.
Pull the left tractor (as seen from the rear) to stretch the paper taut. Push the left
locking lever down to secure the tractor in place.
Cut sheet stand
Locking levers
Paper select lever
Continuous
forms side
Forms
tractors
Tractor guide
Tractor paper holders
Tractor paper holders