Dascom LA48N/LA48W User Guide - Manual (Page 30)

Setting up the printer
2-20
Control Panel Operations
—: This operation has no connection with this condition.
N/A: The condition does not apply because this operation is executed before powerin-
gon.
Operation
Required Conditions
1
Required Action
Ready Printing
2
Fault
Load continuous forms
paper — Not printing On Press FF/Load.
Load single sheet paper — Not printing On Press FF/Load if single
sheetload is switched from
AUTOto MANUAL in Set-Up
mode.
Feed paper a page — Not printing Off Press FF/Load.
Feed paper a line — Not printing Off Press LF.
Advance perforation to
tear bar — Not printing Off Press Pause if the TEARop-
tion is switched from
AUTOto MANUAL in Set-Up
mode,or press FF/Load.
Advance paper for
viewing — Not printing Off Press Pause if the TEARop-
tion is switched from
AUTOto MANUAL in Set-Up
mode.
Return paper to previous
position — Not printing Off Press Pause if the TEARop-
tion is switched from
AUTOto MANUAL in Set-Up
mode,or press FF/Load.
Eject single-sheet paper — Not printing Off Press FF/Load or Park or
turnthe printer off and on
again.
Unload continuous-
forms
3
— Not printing Off Press Park.
Pause printing On Printing Off Press Pause.
Resume printing Blinking Not printing Off Press Pause.
Resume printing after a
fault Off Not printing On Clear error and press
Pause.