Dascom LA48N/LA48W User Guide - Manual (Page 32)

Setting up the printer
2-22
1 In Normal mode operation, all buttons except Pause are inactive in the Busy state in which the printer
isreceiving or printing data.
2 Not printing includes the following situations: the printer is ready and awaiting data, or the Pause button
ispressed and the printer is awaiting data, or the Pause button is pressed during printing.
3 This operation is available in the rear-feeding push-tractor mode.
4 Switching is not done if the printer is holding printing data.
Printer Acoustical Feedbacks
Except for paper handling and when the factory setting for beep is not changed, the
printer beeps in the following ways when you press a control panel button, as fol-
lows.
A short beep indicates that the printer accepts your pressing or specification.
A longer beep indicates that your specification is invalid.
In a certain mode, a middle long beep indicates that the specified mode becomes
activeand a short beep indicates the end of the mode.
When the Fault indicator lights, the printer also makes a longer beep.
Select a Set-Up
Value and move cur-
sor to SAVE&EXIT Off Not printing Off Press Exit/Save.
Quit Set-Up mode
without saving values Off Not printing Off Press Set-Up/Quit.
Clear software-detected
errors — — Blink-
ing Press Pause.
Initialize the printer — — — Turn power off and on
again.
Operation
Required Conditions
1
Required Action
Ready Printing
2
Fault