Dascom LA48N/LA48W User Guide - Manual (Page 47)

Paper Handling
3-15
NOTE:
When you use continuous forms, make sure that the edges of both left and
right paper guides do not touch the paper. Slide both paper guides flush
against the ends of both sides.
Adjustment of the paper guides
Adjusting the Tear-off position
When the FF/Load button is used to advance the paper to cut it, the paper cut posi-
tion and the perforation position may not match. In such cases, adjust their positions
by using the following procedure.
Adjustment procedure
1.
Use the FF/Load button to advance the paper to its cut position.
2.
Press Park and FF/Load buttons simultatneously to enter adjustment mode.
3.
Adjust the Tear-off position by using the following buttons:
button: Pressing this button once extends the paper feed amount by 1/180
inches.
button: Pressing this button once reduces the paper feed amount by 1/180
inches.
Exit/Save button: Saves the adjusted value and exits the adjustment mode.
Setup/Quit button: Exits the adjustment mode without saving the adjusted value.
NOTE:
The adjustment range is plus or minus 63/180 inches (approximately 9 mm).
When it is exceeded, an alarm beeps.
Good Unacceptable
Right paper
guide
Left paper
guide
Continuous
form
Cut sheet
stand