Dascom LA48N/LA48W User Guide - Manual (Page 44)

Paper Handling
3-12
Loading Continuous Forms
This section explains how to use continuous forms. The tractor unit pushes continu-
ous forms.
To load continuous forms paper:
1.
Make sure that the printer is turned on. Remove any single-sheet paper from the
printer.
2.
If necessary, readjust the paper thickness lever for continuous forms. (See the
section “Adjusting for Paper Thickness” earlier in this chapter.)
Paper thickness lever setting
3.
Move the paper select lever to the rear of the printer.
Preparing to load continuous forms paper
4.
Release the tractor locking levers by pulling them up. Open the tractor paper
holders. See the following figure.
Paper thickness lever
No. of Copies Setting
1 1 to 2
2 to 3 2 to 3
4 3 to 4
5 4 to 5
Continuous forms side