Using the control panel, Macrol selection – Dascom LA48N/LA48W User Guide User Manual

Page 58

Text mode
Original mode

Printing

4-2

Using the Control Panel

This printer can directly select some print features from the control panel. These fea-
tures, listed on the control panel, are two predetermined sets (macros) of print fea-
tures and three protocols. Use the following procedures to select Macros and
Protocols:

Macrol selection

Press the Protocol M1 and the Park M2 buttons simultaneously to enter Macro
selection mode. The M1/M2 indicator starts blinking.

Then press within 3 seconds Protocol M1 button to select macro 1 or Park M2
button to select macro 2. If macro 1 is selected, the M1/M2 indicator lights, if
macro 2 is selected the M1/M2 indicator is off.

Macro select mode

Press the Pause button to return the printer to the Ready state. You are ready to
print using the selected macro.

NOTE:

The active Macro at power-off remains active at next power-up.