Apple PC Compatibility Card 7-inch card - Manual (Page 176)

Installing Banyan Vines in DOS
This section describes the settings you must make when using Banyan Vines
with an NDIS driver in DOS. Refer to the documentation that came with
Windows for Workgroups for other installation instructions.
1 Install the Banyan Vines client software.
2 Make sure your configuration files contain the following:
CONFIG.SYS
REM *** BANYAN ***
DEVICE=C:\BANYAN\PROTMAN.DOS /I:C:\BANYAN
DEVICE=C:\BANYAN\MACNDIS.DOS
PROTOCOL.INI (in the directory where the Banyan software is installed)
[VINES_NIF]
DRIVERNAME=NDISBAN$
BINDINGS=MACNDIS
[MACNDIS]
DRIVERNAME=MACNDIS$
PROTOCOLDIX=BAD
Installing NetManage Chameleon TCP/IP software in Windows for Workgroups
This section describes the steps necessary to install the NetManage
Chameleon TCP/IP protocol for use with the either an ODI or NDIS driver in
Windows for Workgroups.
If you are using an ODI-compatible protocol, be sure to install the Novel
NetWare client software first. See “Installing NetWare Client Software”
earlier in this appendix.
1 Run the Chameleon/NFS installer and follow the instructions in the NetManage manual
and on screen.
2 Refer to “Running the Network Protocol Setup (SETNET) Utility” near the end of this
appendix and follow the instructions there.
168 Appendix B