Apple PC Compatibility Card 7-inch card - Manual (Page 157)

IMPORTANT The Windows for Workgroups Network Browser requires more
than 540K of conventional memory. You should maximize conventional
memory by removing unnecessary device drivers and TSRs and by loading
the remaining device drivers and TSRs into high memory, if possible.
1 Install the NetWare client software.
For more information, see “Installing NetWare Client Software” earlier in
this appendix.
2 In the Network Setup control panel, select Drivers, select Add Adapter, and select
“IPXODI Support Driver (Ethernet).”
3 Select “IPX/SPX Compatible Transport With NetBIOS.”
4 Select your frame type.
5 Set the default protocol.
6 If you installed NetWare, you’re asked you if you want to replace the Novell NetWare
drivers. Answer no.
7 Refer to “Running the Network Protocol Setup (SETNET) Utility” near the end of this
appendix and follow the instructions there.
8 Verify that your configuration files contain the following information.
After following the above instructions, your configuration files should contain
the information shown below, assuming a frame type of ETHERNET_802.2
and that NetBEUI is not installed.
NET.CFG
LINK DRIVER MACODI
FRAME ETHERNET_802.2
FRAME ETHERNET_802.3
FRAME ETHERNET_SNAP
FRAME ETHERNET_II
PROTOCOL IPX EO ETHERNET_802.2
149 Installing Network Client Software