Apple PC Compatibility Card 7-inch card - Manual (Page 165)

Installing Novell’s LAN WorkPlace for DOS TCP/IP software
This section describes how to set up the LAN WorkPlace for DOS TCP/IP
protocol for use with an ODI driver.
Follow these steps to install LAN WorkPlace for DOS.
1 Install the NetWare client software.
For more information, see “Installing NetWare Client Software” earlier in
this appendix.
2 Run the installer for LAN WorkPlace for DOS and follow the instructions on the screen.
Let it modify your files.
3 Make sure your NET.CFG file contains the following:
Enter the appropriate addresses for your network configuration. Here are
samples for both DOS/Windows and Windows for Workgroups.
NET.CFG (for DOS/Windows)
LINK DRIVER MACODI
FRAME ETHERNET_802.2
FRAME ETHERNET_II
PROTOCOL IPX E0 ETHERNET_802.2
PROTOCOL IP 800 ETHERNET_II
PROTOCOL ARP 806 ETHERNET_II
LINK SUPPORT
BUFFERS 8 1500
MEMPOOL 4096
PROTOCOL TCPIP
PATH SCRIPT C:\NET\SCRIPT
PATH PROFILE C:\NET\PROFILE
PATH LWP_CFG C:\NET\HSTACC
PATH TCP_CFG C:\NET\TCP
IP_ROUTER
X.X.X.X
IP_NETMASK X.X.X.X
IP_ADDRESS X.X.X.X
Your network administrator can provide the correct numbers to enter for
IP_ROUTER, IP_NETMASK, and IP_ADDRESS.
157 Installing Network Client Software