Apple PC Compatibility Card 7-inch card User Manual

Page 162

You may also include the AUTOEXEC.BAT lines in STARTNET.BAT. If you
do so, be sure to include the following pointer to STARTNET.BAT. from your
AUTOEXEC.BAT file:

@CALL [

PATH]\STARTNET

Note: LSL.COM is the link support layer driver supplied by Novell client
software. MACODI.COM is the network interface driver supplied by Apple.
IPXODI.COM is the IPX/SPX protocol stack layer supplied by Novell client
software. ODIPKT.COM is the ODI packet driver supplied by InterCon
software. The first number represents the frame type, as listed in the
NET.CFG file. Ethernet_II is the last of four frame types (the first is number
0). The second number is the “line number” and should always be set to 107
for Ethernet. WINPKT.COM is the Windows virtual packet driver. It takes as
an argument the line number for the packet driver.

Installing Spry Air Series TCP/IP in Windows for Workgroups

This section describes how to install the Spry Air Series TCP/IP protocol for
use with an ODI driver in Windows for Workgroups.

IMPORTANT

If you have not already installed TCP/IP client software such as

Microsoft TCP/IP-32 or Trumpet Winsock, install it before you install the Air
Series software.

If you are using a VGA driver, and Air Series software version 3.0, you need
to make the following change:

Make sure the Air Series Setup disk is

not read-only.

Place the disk in drive A.

Type the following at the DOS prompt:

A:
MOVE SETUP.BMP SETUP.OLD
COPY C:\WINDOWS\RIVETS.BMP A:SETUP.BMP

154

Appendix B