Apple PC Compatibility Card 7-inch card - Manual (Page 170)

11 Refer to “Running the Network Protocol Setup (SETNET) Utility” near the end of this
appendix and follow the instructions there.
12 After running SETNET, make sure your PROTOCOL.INI file contains the following
(assuming TCP/IP is the only loaded protocol):
PROTOCOL.INI
[ndishlp$]
DriverName=ndishlp$
Bindings=MacNDIS$
[protman$]
DriverName=protman$
priority=ndishlp$
[data]
version=v4.00.950
netcards=MacNDIS$,MacNDIS
[MacNDIS$]
DriverName=MacNDIS$
ProtocolDIX=”800,806,8035”
13 Shut down Windows 95.
14 Switch to the Mac OS by typing x-Return.
15 Click Restart PC in the PC Setup control panel.
Installing NetBEUI and IPX/SPX in Windows for Workgroups
This section describes how to set up the NetBEUI and IPX/SPX protocols
for use with an NDIS driver in Windows for Workgroups. If you are using
ODI, refer to this topic in “Installing Protocols for Use With ODI” earlier in
this appendix.
If you want to install additional protocols, you must modify the
PROTOCOL.INI file accordingly. The Apple Network Setup Utility included
with your PC Compatibility Card can add this information for you.
1 In Windows, open the Network group and select Network Setup.
2 Select Networks, and then select “Install Microsoft Windows Network”; then click OK.
162 Appendix B