beautypg.com

Apple PC Compatibility Card 7-inch card User Manual

Page 159

background image

Installing Microsoft’s TCP/IP-32 IP protocol stack in Windows for
Workgroups

Follow these steps to set up Microsoft’s TCP/IP-32 IP protocol stack for use
with an ODI driver in Windows for Workgroups.

1

Install the NetWare client software.

For more information, see “Installing NetWare Client Software” earlier in
this appendix.

2

Install the protocol stack following the instructions that came with it.

3

Refer to “Running the Network Protocol Setup (SETNET) Utility” near the end of this
appendix and follow the instructions there.

4

After running SETNET, make sure the NET.CFG and PROTOCOL.INI files contain the
sections shown below.

The following entries assume that IPX/SPX support is loaded.

NET.CFG

LINK DRIVER MACODI

FRAME ETHERNET_802.2
FRAME ETHERNET_802.3
FRAME ETHERNET_II
FRAME ETHERNET_SNAP
PROTOCOL IPX E0 ETHERNET_802.2
PROTOCOL IP 800 ETHERNET_II
PROTOCOL ARP 806 ETHERNET_II
PROTOCOL RARP 8035 ETHERNET_II

LINK SUPPORT

MAX BOARDS 4
BUFFERS 4 1500
MEMPOOL 4095

151

Installing Network Client Software