Brocade Communications Systems CNA - Manual (Page 140)

122 Brocade Adapters Administrator’s Guide
53-1001256-01
Port Properties panel (HBA only)
A
Using the property panel
Refer to the following topics for specific procedures using this dialog box:
• “Configuring the port speed using the GUI”
• “Specifying the maximum frame size using the GUI”
• “Specifying the maximum frame size using the GUI”
• “Specifying Path Time Out using the GUI”
• “Configuring the HCM logging level using the GUI”
• “Configuring the queue depth using the GUI”
Queue Depth The number of I/O operations that can be run in parallel on a device.
Interrupt Control Coalesce Indicates whether interrupt control is on or off.
Interrupt Control Latency Sets the interrupt control latency value.
Interrupt Control Delay Sets the interrupt control delay value.
Operating Parameters
Beacon State Indicates whether beaconing is on or off.
Link Beacon State Indicates whether link beaconing is on or off.
MPIO Mode State Indicates whether multipathing mode is on or off.
Path Time Out The value between 0 to 60 that specifies the time out session. Note
you can only enable or edit the path time out when MPIO is disabled.
Logging Level The port logging level. Values include Log Critical, Log Error, Log
Warning, and Log Info.
Persistent Binding Indicates whether persistent binding is on or off.
Target Rate Limit Indicates whether target rate limiting is on or off.
Default Rate Limit Select the target rate limit from the list. Options include 1 Gbps (the
default), 2 Gbps, and 4 Gbps.
FC-SP Parameters
Authentication Indicates whether FC-SP authentication is on or off.
Status The status of FC-SP authentication.
Algorithm The configured authentication algorithm.
Group The DH Group (DH Null, group 0 is the only option).
Error Status The health status of the Fibre Channel Security Protocol parameters.
QoS Parameters
Configured QoS State Indicates whether QoS is enabled or disabled.
Operating QoS State Indicates whether QoS is online or offline.
Total BB Credit The number of receive buffers.
Priority Levels QoS priority levels. Values include High, Medium, and Low.
Field Description