Brocade Communications Systems CNA - Manual (Page 117)

Brocade Adapters Administrator’s Guide 99
53-1001256-01
FCoE port properties (CNA only)
A
Using the property panel
Refer to the following topics for specific procedures using this dialog box:
• “Enabling and disabling rate limiting on the adapter side using the GUI”
• “Enabling and disabling rate limiting on the adapter side using the BCU”
• “Configuring beaconing using the GUI”
• “Configuring beaconing using the GUI”
Operating Speed The configured speed of the FCoE port.
Max Speed Supported The maximum speed that is supported on the FCoE port.
Operating Topology The topology setting. Options include auto, point-to-point, and loop.
Frame Data Field Size The frame size, in bytes, of the FCoE port.
Hardware Path The hardware path of the CNA.
# of Lports The number of logical ports.
Operating Parameters
MPIO Mode State Indicates whether MPIO is on or off.
Path Time Out The value between 0 and 60 that specifies the time-out session.
Note: You can only enable or edit the path time out when MPIO is
disabled.
Logging Level The port logging level. Values include Log Critical, Log Error, Log
Warning, and Log Info.
Target Rate Limit Indicates that target rate limiting is disabled, because this feature is
not supported on the FCoE port.
Default Rate Limit The default rate limit, which is not applicable, because target rate
limiting is not supported on the FCoE port.
FC-SP Parameters
Authentication Indicates whether FC-SP authentication is on or off.
Status The status of FC-SP authentication.
Algorithm The configured authentication algorithm.
Group The DH group, which is DH-null (group 0) which is the only option.
Error Status The health status of the Fibre Channel Security Protocol parameters.
Field Description