Konica Minolta bizhub 362 - Manual (Page 64)

Setting up network printing 3
362/282/222 3-6
6
Enter the IP address, and then touch [Enter].
7
Touch [Subnet Mask] and enter the subnet mask address.
8
Touch [Gateway] and enter the default gateway address.
9
To apply the settings, restart this machine (turn the main power off,
then on again).
Turn this machine back on to apply the IP address.
2
Reminder
When turning the machine off, then on again with the main power switch,
wait about 10 seconds to turn the machine on after turning it off. The ma-
chine may not operate correctly if it is turned on immediately after being
turned off.
!
Detail
Although the IP address is entered without using the DHCP server in the
procedure described here, it is also possible to automatically assign the
IP address from the DHCP server. When “DHCP Configuration” is set to
“Auto-Obtain”, the IP address, subnet mask, and gateway address set-
tings are automatically assigned from the DHCP server on the network,
so it is not necessary to assign them manually. However, note the follow-
ing when setting “DHCP Configuration” to “Auto-Obtain”.
Check with the network administrator that the DHCP server exists. If the
DHCP server does not exist, be sure to specify settings for “IP Address”,
“Subnet Mask”, and “Gateway Address”.