Allied Telesis SwitchBlade x8112 - Manual (Page 50)

Chapter 1: Overview
50
The NET MGMT port has a standard RJ-45 8-pin connector and operates
at 10, 100, or 1000 Mbps in either half- or full-duplex mode. The cable
requirements for this port are the same as the ports on the AT-
SBx81GT24 Line Card, given in Table 1 on page 33. For the port pinouts,
refer to “Port Pinouts” on page 239.
The default setting for the port is Auto-Negotiation, which sets the speed
and duplex mode automatically. You may disable Auto-Negotiation and
configure the port manually. The port is referred to as ETH0 in the
management software.
RADIUS client Used for remote management
authentication and 802.1x port-
based network access control.
RMON with SNMP Used with the RMON portion of
the MIB tree on an SNMP
workstation to remotely monitor
the switch.
Secure Shell server Used to remotely manage the
chassis with a Secure Shell client.
SNMPv1 and v2c Used to remotely manage the
chassis with SNMP.
SNTP client Used to set the date and time on
the controller card, from an NTP or
SNTP server on your network or
the Internet.
Syslog client Used to send the event messages
from the controller card to syslog
servers on the network.
TACACS+ client Used with a TACACS+ server on
your network for remote
management authentication.
Telnet server Used to remotely manage the
chassis with a Telnet client.
TFTP client Used to download files to or
upload files from the controller
card with TFTP.
TRACEROUTE Used to determine the
intermediate nodes (or hops) of
network paths.
Table 12. Features that Use the NET MGMT Port (Continued)
Feature Description