Figure 120: removing the plastic cover – Allied Telesis SwitchBlade x8112 User Manual

Page 166

Text mode
Original mode

Chapter 7: Powering On the Chassis

166

4. Using a #1 Phillips-head screwdriver, remove the two screws that

secure the plastic cover over the positive and negative terminals and
remove the plastic cover from the power supply, as shown in
Figure 120. You may need to lift the locking handle slightly to access
the bottom screw.

Figure 120. Removing the Plastic Cover

Note

The plastic cover is not used with the right angle terminals.

5. Use a #3 Phillips-head screwdriver to remove the two screws from the

positive and negative terminals, as shown in Figure 121 on page 167.