Campbell Scientific CR23X Micrologger - Manual (Page 347)

Section 12. Program Control Instructions
12-3
Stand Alone
Datalogger SendGetData P190 Wireless Sensor P193
Radio Settings Radio address, net address, and hop sequence must be the same in all CR2xxs
and RF400s in the network. Because only one header length can be set for a
radio, only one power cycling interval should be used in network; i.e., do not
mix 8 second and 1 second interval radio power cycling. RF on (no cycling) is
specified where necessary below.
CR205
Power Mode and
Header Select power mode for
appropriate response
time and current drain. Select power mode for
appropriate response
time and current drain.
Header must match
called station’s cycle. NO HEADER.
RfpinEn (lowest power)
or to allow communi-
cation with computer for
checking station, down-
loading program:
RF8_Sec or RF1_sec.
RF400 on CR10X
or CR23X Router, if used, must
send appropriate header Router, if used, must
send appropriate header RF on, header to match
CR205 setting to allow
contacting CR205
Beacon Interval 0 0 0
RF400 on computer RF on, header to match
neighbors’ settings RF on, header to match
neighbors’ settings RF on, header to match
neighbors’ settings
LoggerNet Settings
When RF400 with direct
access to network is
connected to computer.
For each datalogger:
Com
-PbusPort
-logger
For each datalogger
with stored data:
Com
-PbusPort
-logger
For each master
datalogger:
Com
-PbusPort
-logger
PakBus Get/Send Locations (P190)
A program control instruction that sends data to or retrieves data from another
datalogger in a PakBus network. This instruction can also be used to issue
commands to Modbus devices, where the datalogger acts as a Modbus master.
1: PakBus - Get/Send Locations (P190)
1: 00 Port
2: 0000 Address
3: 00 Command
4: 0000 Security
5: 0000 Remote Loc/Coil/Register
6: 0000 Swath
7: 0000 Local Loc [ ______________ ]
8: 0000 Result Code Loc [ ______________ ]