Campbell Scientific CR23X Micrologger - Manual (Page 30)

CR23X MICROLOGGER OVERVIEW
OV-20
09: P74 Minimize instruction
01:1 One repetition
02:10 Output the time of the daily minimum in hours
and minutes
03:2 Data source is Input Storage Location 2.
The program to make the measurements and to send the desired data to Final Storage has
been entered. At this point, Instruction 96 is entered to enable data transfer from Final Storage
to Storage Module.
10:P96 Activate Serial Data Output.
1:71 Output Final Storage data to Storage Module.
The program is complete. (Here the example reverts back to the key by key format.)
Key Display Explanation
∗ 5 00:21:32 Enter ∗ 5 Mode. Clock running but perhaps not set
correctly.
A 05:0000 Advance to location for year.
1 9 9 6 05:1996 Key in year (1996).
A 05:0000 Enter and advance to location for Julian day.
1 9 7 05:197 Key in Julian day.
A 05:0021 Enter and advance to location for hours and minutes (24 hr. time).
1 3 2 4 05:1324 Key in hrs.:min. (1:24 PM in this example).
A :13:24:01 Clock set and running.
∗ 0 Running Table 1 Exit ∗ 5 , compile Table 1, commence logging data.