Campbell Scientific CR23X Micrologger - Manual (Page 306)

TABLE DATA ADDENDUM
AD-4
AD4 Summary of Differences from the Datalogger Manual:
Section Differences
Overview Figure OV2.1-2: See Figure 1.5-1 in Addendum.
Table OV3.2-1: See Table OV4.1-1 in TD Addendum.
OV4, OV5, OV6 :See TD Addendum.
Section 1 Section 1.5 A Mode is replaced by addendum – the TD loggers
allocate memory differently.
Section 1.8 - *D Mode is replaced by TD Addendum – TD loggers do
not support storeing multiple programs or Storage Modules. PakBus
Settings are added to the *D Mode.
Section 2 Replaced entirely by TD Addendum.
Section 3 Section 3.7.1 does not apply to the TD operating system which does
not use Output Flag 0.
Table 3.8-1 Valid Flag Commands are 11 – 19 to set high and 21- 29
to set Low. Because the TD operating system does not use Flag 0,
Commands 10 and 20 are not valid with the TD operating system.
Table 3.10-1 TD Addendum. has a corrected version
Section 4 Does not apply: The TD operating system does not support External
Storage Peripherals.
Section 5 Does not apply: The communications commands and protocol of the
TD operating system is different than that of the standard operating
systems. Campbell Scientific provides software for communications;
a description of the protocol is beyond the scope of this addendum.
Section 6 Many of the peripherals discussed in section 6 are not supported by
the TD operating system.
Section 7 No Change
Section 8 Replaced entirely by TD Addendum.
Section 9 Instruction 18 has some differences in the time options, see
addendum.
Section 10 No Change
Section 11 Instructions 73 and 74 have only one option for storing the time of
max or min (time is output as a quoted string).
Instruction 80 – Set Active Storage Area, is not in the TD operating
system. Its functions are included in Instruction 84 – Data Table.
Instruction 84 – Data Table, sets the conditions and destination for
output data. This instruction is only in the TD operating system (see
TD Addendum..)