Vaisala Hydromet Data Collection Platform - Manual (Page 128)

User's Guide ______________________________________________________________________
126 __________________________________________________________________M210784EN-E
NOTE When Value is expressed as
N/A
, it indicates that the calibration factor
has been altered but not saved, the sensor has not been measured or its
measurement channel has failed, or the sensor is disabled. Further
information about the possible reason can be obtained by comparing
the value in the Status column against the values listed in
Table 30 on
page 127 .
Table 29 Columns in the Sensor Calibration Tab
Column Description Input
Sensor The sensor name as
defined in the setup n/a
Channel The measurement channel
of the sensor n/a
ID The measurement identifier n/a
Status The sensor status n/a
Offset Offset for the sensors Overwrites the old offset value
with the new one.
Sensitivity The sensitivity value for the
radiation sensors (QMN10x
and QMS10x) Overwrites the sensor
sensitivity value for the
radiation sensors.
Factor Measurement gain for the
sensors other than
radiation sensors Overwrites the old gain value
with the new one.
Value The last measured sensor
reading shown in physical
units Overwrites the sensor reading
with the entered value, that is,
changes the offset of the
measurement.