Vaisala Hydromet Data Collection Platform - Manual (Page 110)

User's Guide ______________________________________________________________________
108 __________________________________________________________________M210784EN-E
paramset paramset [<set> <parameter> [<value>]]. To list all parameter sets, type
paramset without any parameters. To show the values of all parameters in
a given set, type paramset <set>. To show the value of a parameter in a
set, type paramset <set> <parameter>. To set the value of a parameter in a
set, type paramset <set> <parameter> <value>.
ping ping <destination IP address of host name>. Tests access to a host based
on its IP address or DNS name.
pslevel pslevel [meters]. To see the current pressure sensor level, type pslevel. To
change the pressure sensor level, type pslevel and the new pressure
sensor level in meters from the station altitude.
rd rd <directory> removes a directory.
rep rep <report_name> shows the contents of a report. For example: rep
MyRep0.
reset reset [delay (seconds)] resets the QML logger (warm boot). If the delay time
is not given, the logger resets immediately.
serial serial <port> [> <parity> <bits> <stop>]. To see the settings of the
port number 0, type serial 0. To change the settings, type serial 0 and the
new parameters. For example: serial 0 9600 N 8 1. Available ranges/
options: Speed 300-19200, Parity N/O/E, Bits 7/8, Stop 0/1.
SLEEP Sets the system in low power-state. Use the SLEEP command to reduce
power consumption when storing the station for a few days (maximum
period 1 month). Tip the spoon of the rain gauge to awaken the system. It
can also be awakened by pressing the reset button. Note that the SLEEP
command must be written in upper case.
sname sname [station_name]. To see the current station name, type sname. To
change the name, type sname and the new name. If the station name
begins with a digit or contains a space, the name must be in quotes, for
example, sname "Vaisala MAWS".
spclear spclear <parameter | ALL> clears a static parameter or all parameters.
Note that this command clears QMS101 and QMN101 sensitivity settings
and is usually not needed.
spset spset [parameter] [value] sets a value to a static parameter. To see a list of
static parameters, type spset. NOTE! This command is not usually needed.
SYSINFO SYSINFO gives information on the system. Note that the command must be
written in upper case.
time time [HH MM SS YY MM DD]. To see the current time, type time. To
change the current time, type time and the new time. For example: time 14
10 00. To change the current date, type time and the new time and date. For
example: time 14 10 00 98 12 31.
timezone timezone [hours] sets the time difference from UTC. To see the time zone,
type timezone. To set the time zone, type, for example, timezone 2.
userlevel userlevel [level ] command is used to protect system from
unauthorized use. It provides three password protected access levels to
shell commands as well as to the visibility of system data. By default, the
user levels are not in use.
verify verify <source file> [destination file] compares two files. If they are different,
the response is: Error: Files are different.
Table 22 Command Set (Continued)
Command Description