Vaisala Hydromet Data Collection Platform - Manual (Page 127)

Chapter 4 ___________________________________________________________ Troubleshooting
VAISALA______________________________________________________________________ 125
0802-146 Figure 60 Settings Menu: Calibration Window
CAUTION When an early QML logger version is updated to above 3.06, the
following sensors will not operate correctly in the Sensor Calibration
tab until they are removed from the setup and then re-created: CM6B,
CM11, QMS101, QMS102, and QMN101.
NOTE You must load an appropriate setup to the QML logger before you are
able to use the Sensor Calibration tab.
NOTE The Sensor Calibration tab is not visible for setups made with the
software versions prior to 3.06. With old setups, the MAWS common
parameters frame only shows the calibration values for the wind
direction and solar radiation sensors. Other sensors need to be
calibrated through the terminal connection with the appropriate
calibration commands.