Ag Leader ParaDyme Radio Option Kits Hardware Installation Guide - Manual (Page 3)

Hardware Installation Guide iii
Special Requirements
Tools
This list consists of special tools required to complete the installation. A complete set of common installation tools is assumed.
Technical Support
Refer to your owner's manual for technical support information.
Contact Information
Refer to your owner's manual for contact information.
Copyright © 2011 All Rights Reserved.
ESDS Anti-electrostatic wrist strap 5/8" open wrench 12mm open wrench
2" x 4"x 10" wood spacer blocks (or
other spacer) #0 Phillips screwdriver 24mm open wrench
8mm Open End Torque Wrench
a
((set to 8in-lbs (0.9 Newton meters))
a. In order to prevent possible damage during assembly use the correct torque specification and tools. An adjustable
torque driver can be used in place of multiple preset torque drivers. Failure to use the correct tools and
procedures may void the manufacturer's warranty.
#1 Phillips screwdriver 8mm Allen wrench
Torque driver with #0 Phillips bit
a
((set to 2in-lbs (0.2 Newton meters))
#2 Phillips screwdriver Ten Foot Ladder
Torque driver with #1 Phillips bit
a
((set to 5in-lbs (0.6 Newton meters))
Wire cutters Cleaning rags and cleaning brush
Torque driver with #2 Phillips bit
a
((set to 20in-lbs (2.3 Newton meters))
Flat screwdriver