Ag Leader ParaDyme Radio Option Kits Hardware Installation Guide - Manual (Page 23)

Hardware Installation Guide 17
Preparation
6. Remove the ParaDyme Smart Antenna bottom cover to access the component mounting locations.
Figure 4-4 Cover Removed and Component Mounting Locations Identified
Note: This figure shows only the Cell Modem installed. Depending on which options have been already installed,
your Roof Module may appear different than the figure.
Note: The Cell Modem installed in your ParaDyme may be different than the one shown in the figure.
Note: Always wear an electrostatic discharge wrist strap when handling a printed circuit board. Failure to use an
electrostatic discharge wrist strap may cause permanent damage to the printed circuit board and void the warranty.
7. Refer to one or more of the following sections for instructions on installing your kit or kits.
•
Changing or Installing a SIM Card on page 18
•
OmniSTAR Receiver Kit Installation Procedure (200-0504-02 Kit) on page 21
•
900 MHz RTK Radio Modem Kit Installation Procedure (200-0505-04 Kit) on page 24
•
UHF and VHF Radio Modem Kit Installation Procedure on page 32
UHF/VHF Radio Module Mounting Location
900 MHz Radio Module Mounting Location
OmniSTAR Module Mounting Location
Cell Modem Location
SIM Card Mounting Location