Ag Leader ParaDyme Radio Option Kits Hardware Installation Guide - Manual (Page 11)

Hardware Installation Guide 5
RF Exposure Information
Note: Radio modems users in North America should be aware that due to the allocation of the frequency band 406.0 -
406.1 MHz to be used for government use only, the use of radio modem on this frequency band without a proper permit
is strictly forbidden.
RF Exposure Information
Configurations using radio modules not described above or which use antennas not qualified for the radio modules above
require further equipment authorization.
ESDS Precautions
An Electrostatic Discharge Sensitive (ESDS) device is an electronic component which can be damaged by an electrostatic
charge or discharge through its assemblies and conductors.
ESDS devices are identified by the following symbol:
Handling Requirements
Observe special handling procedures required for ESDS devices. Failure to follow these procedures can result in equipment
damage. Use an anti-electrostatic wrist strap when handling ESDS devices.
CAUTION
FCC RF Exposure Requirements
The antennas connected to the radios listed in Table 2-1 on
page 4 must be mounted at least 26.6 cm away from nearby
persons to comply to FCC RF exposure requirements.
CAUTION
ESDS Device Requirements
This equipment contains parts and assemblies sensitive to
damage by electrostatic discharge (ESD). Use ESDS
precautionary procedures when touching, removing, or
installing assemblies.