Ag Leader ParaDyme Radio Option Kits Hardware Installation Guide - Manual (Page 22)

16 Radio Option Kits
Preparation
3. Place the Roof Module upside down on a flat bench. Use the original packing material, wood spacers, or some other block
under the Roof Module at each end to stabilize the unit to prevent damage to the GPS and cell phone antennas as shown in
Figure 4-2
Figure 4-2 Figure 4-2 ParaDyme Receiver
4. Clean the Roof Module with a damp cloth to remove any debris.
5. Using a #2 Phillips screwdriver, remove the 13 screws holding the cover to the bottom of the ParaDyme Smart Antenna.
Figure 4-3 Remove Bottom Cover Screws from ParaDyme Smart Antenna
ParaDyme Smart Antenna Bottom Cover