HP 4000.6000.8000 Enterprise Virtual Arrays - Manual (Page 97)

3. To help identify the correct enclosure, click Locate > Locate On to display Locate Confirmed
on the controller operator control panel (OCP). The blue Unit ID indicator will also turn on.
• Check the power supply status indicator. See Figure 44 . It should be amber or off.
Figure 44 Power supply status indicator
1. Status indicator 2. Power supply 0
3. Power supply 1
Removing a power supply
1. Disconnect the AC power cord from the power supply.
2. While moving the wine-colored latch to the left (1, Removing a power supply ), grasp the handle and
pull the power supply out of the enclosure (2).
0139a
Figure 45 Removing a power supply
Installing a power supply
1. Remove any connector protector that may be covering the AC power connector on the new power
supply.
2. While pressing in on the mounting latch (1, Installing a power supply ), slide the power supply into
the enclosure until it is fully seated (2).
3. Connect the AC power cord to the power supply.
4000/6000/8000 Enterprise Virtual Array user guide 97