HP 4000.6000.8000 Enterprise Virtual Arrays - Manual (Page 31)

0108b
1
Figure 5 Location of the World Wide Name labels
1. World Wide Name labels
Complete the following procedure to assign the WWN to each pair of controllers.
1. Turn the power switches on both controllers off.
2. Apply power to the rack.
3. Turn the power switch on both controllers on.
NOTE:
Notifications of the startup test steps that have been executed are displayed while the
controller is booting. It may take up to two minutes for the steps to display. The default
WWN entry display has a 0 in each of the 16 positions.
4. Press or until the first character of the WWN is displayed. Press to accept this character
and select the next.
5. Repeat Step 4 to enter the remaining characters.
6. Press Enter to accept the WWN and select the checksum entry mode.
Entering the WWN checksum
The second part of the WWN entry procedure is to enter the two-character checksum, as follows.
1. Verify that the initial WWN checksum displays 0 in both positions.
2. Press or until the first checksum character is displayed. Press to accept this character and
select the second character.
3. Press or until the second character is displayed. Press Enter to accept the checksum and exit.
4. Verify that the default display is automatically selected. This indicates that the checksum is valid.
NOTE:
If you enter an incorrect WWN or checksum, the system will reject the data and you must repeat the
procedure.
Entering the storage system password
The eight-character storage system password feature enables you to restrict management access to the
storage system.
Complete the following procedure to set the password:
1. Select a unique, eight-character password.
4000/6000/8000 Enterprise Virtual Array user guide 31