HP 4000.6000.8000 Enterprise Virtual Arrays - Manual (Page 73)

Table 24 Menu options within the OCP display
System Information
Menu
Fault Management Menu Shutdown options
Menu
System Password
Menu
Versions Last Fault Restart Change Password
Host Port Config
(Sets Fabric or Direct
Connect)
Detail View Power Off Clear Password
Device Port Config
(Enables/disables device
ports)
Uninitialize System Current Password
(Set or not)
IO Module Config
(Enables/disables
auto-bypass)
Loop Recovery Config
(Enables/disables
recoveries)
Unbypass Devices
UUID Unique Half
Debug Flags
Print Flags
Mastership Status
(Displays controller role —
master or slave)
Displaying system information
NOTE:
The purpose of this information is to assist the HP-authorized service representative when servicing
your system.
The system information displays show the system configuration including the XCS version, the OCP
firmware and application programming interface (API) versions, and the enclosure address bus
programmable integrated circuit (PIC) configuration. You can only view, not change, this information.
Displaying versions system information
When you press , the active display is Versions. From the Versions display you can determine the:
• OCP firmware version
• Controller version
• XCS version
NOTE:
The terms PPC, Sprite, Glue, SDC, CBIC, and Atlantis are for development purposes and have no
significance for normal operation.
4000/6000/8000 Enterprise Virtual Array user guide 73