Adding a disk to the group, Returning the failed component, Replacing the disk enclosure power supply/blower – HP 4000.6000.8000 Enterprise Virtual Arrays User Manual
Page 101: Before you begin
NOTE:
It may take up to 10 minutes for the component to display good status.
•
Check the disk drive status indicators. See
• Activity indicator (1) should be on or flashing
• Online indicator (2) should be on or flashing
• Fault indicator (3) should be off
•
Check the following using Command View EVA.
• Navigate back to the component and check the operational state. It should be
.
• Ensure the disk drive is using the correct firmware. Check the Firmware Version against the
supported disk firmware in the HP StorageWorks Enterprise Virtual Array release notes. The
most current edition of the release notes can be downloaded from the following web site:
Click Technical documentation.
If the disk drive is using an unsupported version of firmware, download the correct firmware
from the following web site and install it using the instructions included with the firmware file.
Do not add the disk drive to a disk group if it using an unsupported firmware version.
Adding a disk to the group
After replacing the disk, it should be added to a disk group. The disk is typically added back into
its original disk group.
1.
In the Navigation pane, select Storage system > Hardware > Rack > Disk enclosure > Bay
2.
In the Content pane, select the Disk Drive tab.
3.
Click Group to initiate the process for adding the disk to a disk group.
NOTE:
If the Device Addition Policy is set to automatic, the disk will automatically be added to a disk group. In
this case the Group option will not be available.
Returning the failed component
Please follow the return instructions provided with the new component.
Replacing the disk enclosure power supply/blower
This section describes the procedure for replacing the power supply/blower assembly used in EVA
4000/6000/8000 products.
NOTE:
Because this component is used in several products, the drawings may reflect a different enclosure than
the one you have. The removal and replacement procedure is the same for each product.
Before you begin
Observe the following precautions when replacing the power supply/blower.
4000/6000/8000 Enterprise Virtual Array user guide
101