HP XP P9500 Storage - Manual (Page 50)

Table 10 Business Continuity Manager identification of storage system models and serial numbers
What is considered to be a storage system
serial number What is considered
to be a storage
system Storage system model
Physical DKC serial number Storage system XP1024/XP128 or XP12000/XP10000
disk array
Logical DKC serial number Logical DKC XP24000/XP20000 or XP P9500 disk
array
Setting up Business Continuity Manager
After Business Continuity Manager is installed and configured for each data center in the
configuration, you must perform some initial setup tasks. For more information about these tasks,
see
“Preparing to use Business Continuity Manager” (page 117)
NOTE: Some of these tasks must be performed for each site in the configuration. For detailed
information, see “Configuration definitions” (page 142) .
Each of the following tasks can be selected from an item on the Main Menu ISPF panel.
•
Scan each site to acquire information about the volumes; transfer this information to the primary
site. See
“Acquiring volume information” (page 588) .
•
Define and establish a set of inter-control unit logical paths or inter-disk controller logical paths.
See
“Creating a path set” (page 595) .
•
Define the route list. See “Defining a route list” (page 611) .
•
Register a command device in a storage system. See “Setting up Storage Systems” (page 118) .
•
Define a copy group. See “Defining a copy group” (page 646) .
50 Overview of HP XP P9000 for Business Continuity Manager Software