HP Surestore 64 Director Switch - Manual (Page 198)

182 Appendix
Cannot run diagnostics on an
uninstalled port. Port diagnostics cannot be performed on a port that is not
installed. Run diagnostics only on a port that is installed.
Cannot run diagnostics while a
device is logged-in to the port. A device is logged in to the port where a diagnostic test is
attempted. Log out the device and run the diagnostic test again.
Cannot save port configuration. Port configuration cannot be saved. The link is down or busy.
Retry the operation later. If the condition persists, contact
support personnel.
Cannot save SNMP
configuration. SNMP configuration cannot be saved. The link is down or busy.
Retry the operation later. If the condition persists, contact
support personnel.
Cannot set Fibre Channel
parameters. Fibre Channel parameters cannot be set. The link is down or
busy. Retry the operation later. If the condition persists, contact
support personnel.
Cannot set director date and
time. Director date and time cannot be set. The link is down or busy.
Retry the operation later. If the condition persists, contact
support personnel.
Cannot set director state. Director state cannot be set. The link is down or busy. Retry the
operation later. If the condition persists, contact support
personnel.
Cannot set write authorization
without defining a community
name. A community name was not defined in the Configure SNMP
dialog box for the write authorization selected. Provide a name
in the name field where write authorization is checked.
Cannot start data collection. Data collection cannot be started. The link is down or busy.
Retry the operation later. If the condition persists, contact
support personnel.
Cannot start firmware install
while CTP synchronization is in
progress. CTP synchronization is in progress while you are attempting to
install firmware. Wait for the CTP synchronization to complete
before starting the firmware install.
Cannot start port diagnostics. Port diagnostics cannot be started. The link is down or busy.
Retry the operation later. If the condition persists, contact
support personnel.
Click OK to remove all contents
from log.
Requesting confirmation that you want all contents removed
from the log. Click
OK to continue or click Cancel to end the
operation.
Message Cause/Solution