HP Surestore 64 Director Switch - Manual (Page 191)

Reset Configuration 175
Us
ing M
a
in
tena
nce
Fe
ature
s
Reset Configuration
Note You must have maintenance authorization rights to access this feature.
This feature is used to reset all configuration data for the director to factory default values.
Notes
Please note that since the internet protocol (IP) address will reset to the factory default
value (refer to Table 4) during this procedure, you may not recover the Ethernet
connection between the director and HP EFC server if you have changed the director ‘s IP
addressing from that default value. In this case you must re-enter LAN addressing, such as
IP and gateway addresses, through a terminal attached to the maintenance port.
Before using the reset configuration option, record the director’s current IP address, which
displays below the switch’s icon in the HP EFC Manager’s Product View (view Display
Options set to Network Address). You can also find the current IP address through the
embedded web-server interface.
After resetting the configuration, reset LAN addressing to the desired values through the
maintenance port or the embedded web-server interface.
Use of the maintenance port is not covered in this manual. Refer to the installation chapter
in the hp surestore director fc-64 Installation and Service Manual (HP A6534-90902) for
procedures.
Procedure
Use the following steps to reset the configuration parameters on the director to the default
values.
1. Select Reset Configuration from the Maintenance menu. The following warning
displays: