HP Surestore 64 Director Switch - Manual (Page 155)

Configure Threshold Alerts 139
Config
uring the
Di
re
ctor
Figure 55 Configure Threshold Alerts Dialog Box - Alert Activated
Modify Alerts
Use the following steps to modify an existing threshold alert configuration.
1. Select Threshold Alerts from the Configure menu.
The Configure Threshold Alerts dialog box displays.
2. Select the alert that you want to modify by clicking the alert information in the table.
3. If the alert is active, select Deactivate, then select the alert information in the table
again.
4. Select Modify.
If the alert is active, an error message displays prompting you deactivate the alert.
An initial Modify Threshold screen appears where you can change the threshold type.
5. Select a threshold type from the drop-down list.