HP LaserJet M4349 Multifunction Printer series - Manual (Page 55)

Menu item Sub-menu item Sub-menu item Values Description
Fax Send Settings Fax Dial Volume Off
Medium (default)
High
Use this feature to set the volume of the tones
that you hear while the device dials the fax
number.
Error Correction
Mode Enabled (default)
Disabled
When Error Correction Mode is enabled and
an error occurs during fax transmission, the
device sends or receives the error portion
again.
JBIG Compression Disabled
Enabled (default)
The JBIG Compression reduces fax-
transmission time, which can result in lower
phone charges. However, using JBIG
Compression sometimes causes
compatibility problems with older fax
machines. If this occurs, turn off the JBIG
Compression.
Maximum Baud Rate Select a value from
the list. Use this feature to set the maximum baud
rate for receiving faxes. This can be used as
a diagnostic tool for troubleshooting fax
problems.
Dialing Mode Tone (default)
Pulse
Select whether the device should use tone or
pulse dialing.
Redial On Busy The range is between
0 and 9. The factory
default is 3 times. Type the number of times the device should
attempt to redial if the line is busy.
Redial On No Answer Never (default)
Once
Twice
Use this feature to specify the number of
times the device should attempt to dial if the
recipient fax number does not answer.
NOTE: Twice is available in locations other
than the United States and Canada.
Redial Interval The range is between
1 and 5 minutes. The
factory default is 5
minutes. Use this feature to specify the number of
minutes between dialing attempts if the
recipient number is busy or not answering.
Detect Dial Tone Enabled
Disabled (default)
Use this feature to specify whether the device
should check for a dial tone before sending a
fax.
Dialing Prefix Off (default)
Custom
Use this feature to specify a prefix number
that must be dialed when sending faxes from
the device.
Billing Codes Off (default)
Custom
When billing codes are enabled, a prompt
appears that asks the user to enter the billing
code for an outgoing fax.
Minimum Length The range is between 1 and 16 digits. The default is 1 digit.
Table 2-11 Fax Setup menu (continued)
ENWW Initial Setup menu 41