HP LaserJet M4349 Multifunction Printer series - Manual (Page 191)

Control panel message Description Recommended action
55.XX.YY DC CONTROLLER ERROR To
continue turn off then on The print engine is not communicating with
the formatter. Turn the MFP off, and then turn the MFP on.
If this message persists, contact your dealer
for support, or go to
www.hp.com/support/
ljm4349mfp .
56.X ERROR To continue turn off then on A temporary printing error has occurred. Turn the MFP off, and then turn the MFP on.
If this message persists, contact your dealer
for support, or go to
www.hp.com/support/
ljm4349mfp .
57.XX ERROR To continue turn off then on A temporary printing error has occurred. Turn the MFP off, and then turn the MFP on.
If this message persists, contact dealer for
support, or go to
www.hp.com/support/
ljm4349mfp .
58.XX ERROR To continue turn off then on A temporary printing error has occurred. Turn the MFP off, and then turn the MFP on.
If this message persists, contact your dealer
for support, or go to
www.hp.com/support/
ljm4349mfp .
59.XY ERROR To continue turn off then on A temporary printing error has occurred. Turn the MFP off, and then turn the MFP on.
If this message persists, contact your dealer
for support, or go to
www.hp.com/support/
ljm4349mfp .
60.X ERROR To continue turn off then on The tray specified by X is not lifting correctly. Follow the instructions in the onscreen dialog
box.
62 NO SYSTEM To continue turn off then
on A problem exists with the MFP firmware. Turn the MFP off, and then turn the MFP on.
If this message persists, contact your dealer
for support, or go to
www.hp.com/support/
ljm4349mfp .
64 ERROR To continue turn off then on A scan buffer error occurred. Turn the MFP off, and then turn the MFP on.
If this message persists, contact your dealer
for support, or go to
www.hp.com/support/
ljm4349mfp .
66.XY.ZZ OUTPUT DEVICE FAILURE An error occurred in an external paper-
handling accessory. 1. Turn the MFP power off.
2. Check that the accessory is properly
seated on and connected to the MFP,
without any gaps between the MFP and
the accessory. If the accessory uses
cables, disconnect and reconnect them.
3. Verify that there is no packaging
material in or around the output device.
4. Turn the MFP power on.
5. If this message persists, contact your
dealer for support, or go to
www.hp.com/support/ljm4349mfp .
Table 11-1 Control-panel messages (continued)
ENWW Control-panel messages 177