HP LaserJet M4349 Multifunction Printer series - Manual (Page 48)

Menu item Sub-menu item Sub-menu item Values and Description
Default IP Specify the IP address to default to when the print
server is unable to obtain an IP address from the
network during a forced TCP/IP reconfiguration (for
example, when manually configured to use BootP or
DHCP).
Auto IP : A link-local IP address 169.254.x.x is set.
Legacy : The address 192.0.0.192 is set, consistent
with older HP Jetdirect devices.
Primary DNS Specify the IP address (n.n.n.n) of a Primary DNS
Server.
Secondary DNS Specify the IP address (n.n.n.n) of a Secondary
Domain Name System (DNS) Server.
IPV6 Settings Enable Use this item to enable or disable IPv6 operation on the
print server.
Off (default): IPv6 is disabled.
On : IPv6 is enabled.
Address Use this item to manually configure an IPv6 address.
Manual Settings : Use the Manual Settings menu to
enable and manually configure a TCP/ IPv6 address.
DHCPV6 Policy Router Specified : The stateful auto-configuration
method to be used by the print server is determined by
a router. The router specifies whether the print server
obtains its address, its configuration information, or
both from a DHCPv6 server.
Router Unavailable : If a router is not available, the print
server should attempt to obtain its stateful
configuration from a DHCPv6 server.
Always : Whether or not a router is available, the print
server always attempts to obtain its stateful
configuration from a DHCPv6 server.
Primary DNS Use this item to specify an IPv6 address for a primary
DNS server that the print server should use.
Manual Settings Use this item to manually set IPv6 addresses on the
print server.
Enable : Select this item and choose On to enable
manual configuration, or Off to disable manual
configuration.
Address : Use this item to type a 32 hexadecimal digit
IPv6 node address that uses the colon hexadecimal
syntax.
Table 2-10 Jetdirect menus (continued)
34 Chapter 2 Control Panel ENWW