Initial setup menu, Networking and i/o – HP LaserJet M4349 Multifunction Printer series User Manual
Page 46
Initial Setup menu
The
Initial Setup
menu contains the sub-menus shown:
●
Networking and I/O
menu
●
Fax Setup
menu
●
E-mail Setup
menu
NOTE:
Values shown with "(default)" are the factory-default values. Some menu items have no default.
Networking and I/O
Table 2-9
Networking and I/O
Menu item
Sub-menu item
Values
Description
I/O Timeout
Select a value in the
range. The factory default
setting is 15 seconds.
I/O timeout refers to the elapsed time before a print job
fails. If the stream of data that the device receives for
a print job gets interrupted, this setting indicates how
long the device will wait before it reports that the job
has failed.
Parallel Input
NOTE:
This item
appears only if an EIO
accessory is installed.
High Speed
No
Yes
(default)
Use the
High Speed
setting to configure the speed that
the parallel port uses to communicate with the host.
Advanced Functions
Enabled
(default)
Disabled
Use the
Advanced Functions
setting to enable or
disable bidirectional parallel communication.
Embedded Jetdirect
See
Table 2-10 Jetdirect menus on page 32
for the list of options.
EIO
Table 2-10
Jetdirect menus
Menu item
Sub-menu item
Sub-menu item
Values and Description
TCP/IP
Enable
Off
: Disable the TCP/IP protocol.
On
(default): Enable the TCP/IP protocol.
Host Name
An alphanumeric string, up to 32 characters, used to
identify the device. This name is listed on the
HP Jetdirect configuration page. The default host name
is NPIxxxxxx, where xxxxxx is the last six digits of the
LAN hardware (MAC) address.
32
Chapter 2 Control Panel
ENWW