Enww control-panel messages 181 – HP LaserJet M4349 Multifunction Printer series User Manual
Page 195
Control panel message
Description
Recommended action
Novel login required
Novell authentication has been enabled for
this destination.
Enter Novell network credentials to access
the requested feature.
Order cartridge
The number of pages remaining for the print
cartridge has reached the low threshold. The
MFP was set to stop printing when a supply
needs to be ordered.
Touch OK to continue printing until the print
cartridge is out of toner.
To order a new print cartridge, see
parts, accessories, and supplies
on page 228
.
Output bin
The specified output bin is full and printing
cannot continue.
Empty the bin to continue printing.
Output paper path open
The paper path between the MFP and the
output device is open and must be closed
before printing can continue.
1.
If you have a 3-bin mailbox installed,
make sure the jam-access door is
closed.
2.
If you have a stapler/stacker installed,
make sure the staple cartridge is
snapped into position and that the
staple-cartridge door is closed.
PAPER WRAPPED AROUND FUSER
A jam has occurred because paper has
wrapped around the fuser.
Follow the instructions in the onscreen dialog
box. See
.
Password or name is incorrect. Please
enter correct login.
The user name or password was typed
incorrectly.
Retype the user name and password.
PIN is incorrect. Please enter a 4-digit
number.
The PIN format is incorrect.
Type the 4-digit PIN.
PIN is incorrect. Please re-enter PIN.
The PIN was typed incorrectly.
Retype the PIN.
Please turn device off and install hard
disk.
The requested job requires a hard disk, but
the MFP does not have a hard disk installed.
Turn the MFP off and install a hard disk. See
Order parts, accessories, and supplies
on page 228
.
Reattach output bin
The standard output bin was detached when
the MFP was turned on, or the cable on the
stapler/stacker or the 3-bin mailbox is not
connected to the MFP.
Turn the MFP off. If you are using the stapler/
stacker or the 3-bin mailbox, make sure that
the cable is connected to the MFP. Reattach
the output bin, and then turn the MFP on.
Observe the LED on the output device. If it is
flashing or amber, see
.
Reinsert duplexer
The duplexer has been removed and must be
reinstalled.
Reinsert the duplexer in the MFP.
Reinstall output device
The output device has been removed or is not
attached.
Make sure the output bin, 3-bin mailbox, or
stapler/stacker is correctly installed on the
MFP.
Replace cartridge
The print cartridge has reached the end of its
life. Printing cannot continue.
Replace the print cartridge. To order a new
print cartridge, see
Replace staple cartridge
The stapler is out of staples.
Replace the staple cartridge. For information
about replacing the staple cartridge see
Order parts, accessories, and supplies
on page 228
.
SANITIZING DISK
not power off
The hard disk is being cleaned.
Contact the network administrator.
Table 11-1
Control-panel messages (continued)
ENWW
Control-panel messages 181