HP LaserJet M4349 Multifunction Printer series - Manual (Page 122)

Print on both sides of the paper
When duplex printing is available, you can automatically print on both sides of a page. If duplex printing
is not available, you can manually print on both sides of a page by feeding the paper through the product
a second time.
NOTE: In the printer driver, Print on Both Sides (manually) is available only when duplex printing is
not available or when duplex printing does not support the type of print media being used.
To configure the product for automatic or manual duplex printing, open the printer-driver properties, click
the Device Settings tab, and then select the appropriate settings under Installable Options.
NOTE: The Device Settings tab is not available from within software programs.
NOTE: The procedure to open the printer-driver properties depends on the operating system that you
are using. For information about opening the printer-driver properties for your operating system, see
Open the printer drivers on page 14 . Look for the column titled "To change the device configuration
settings".
Use automatic duplex printing
1. Insert enough paper into one of the trays to accommodate the print job. If you are loading special
paper such as letterhead, load it in one of the following ways:
● For tray 1, load the letterhead paper with the front side up, bottom-edge first.
● For all other trays, load the letterhead paper with front side down, and the top edge at the
back of the tray.
CAUTION: To avoid jams, do not load paper that is heavier than 105 g/m 2 (28 lb bond).
2. Open the printer driver (see Open the printer drivers on page 14 ).
3. On the Finishing tab, click Print on Both Sides.
● If necessary, select Flip Pages Up to change the manner in which pages are turned, or select
a binding option in the Booklet Layout list box.
4. Click OK.
108 Chapter 6 Print ENWW