Enww initial setup menu 37 – HP LaserJet M4349 Multifunction Printer series User Manual
Page 51
Menu item
Sub-menu item
Sub-menu item
Values and Description
SNMP Test
This test checks operation of SNMP communications
by accessing predefined SNMP objects on the device.
Select
Yes
to choose this test, or
No
to not choose it.
Select All Tests
Use this item to select all available embedded tests.
Select
Yes
to choose all tests. Select
No
to select
individual tests.
Data Path Test
This test helps to identify data path and corruption
problems on an HP postscript level 3 emulation device.
It sends a predefined PS file to the device, However,
the test is paperless; the file will not print.
Select
Yes
to choose this test, or
No
to not choose it.
Execution Time [H]
Use this item to specify the length of time (in hours) that
an embedded test will be run. You can select a value
from 1 to 60 hours. If you select zero (0), the test runs
indefinitely until an error occurs or device is turned off.
Data gathered from the HTTP, SNMP, and Data Path
tests is printed after the tests have completed.
Execute
No
*: Do not initiate the selected tests.
Yes
: Initiate the selected tests.
Ping Test
This test is used to check network communications.
This test sends link-level packets to a remote network
host, then waits for an appropriate response. To run a
ping test, set the following items:
Dest Type
Specify whether the target device is an IPv4 or IPv6
node.
Dest IP
IPV4
: Type the IPv4 address.
IPV6
: Type the IPv6 address.
Packet Size
Specify the size of each packet, in bytes, to be sent to
the remote host. The minimum is 64 (default) and the
maximum is 2048.
Timeout
Specify the length of time, in seconds, to wait for a
response from the remote host. The default is 1 and
the maximum is 100.
Count
Specify the number of ping test packets to send for this
test. Select a value from 1 to 100. To configure the test
to run continuously, select 0.
Print Results
If the ping test was not set for continuous operation,
you can choose to print the test results. Select
Yes
to
print results. If you select
No
(default), results are not
printed.
Execute
Specify whether to initiate the ping test. Select
Yes
to
initiate the test, or
No
to not run the test.
Table 2-10
Jetdirect menus (continued)
ENWW
Initial Setup menu
37